I am testing out NAP for DHCP an I am trying to set up "reporting mode."
I see tons of references to suggesting use of reporting mode, but I don't see exactly how that is set up.
I am assuming it is set up by creating polices and setting it to grant access for both compliant and non-compliant computers.
However, despite no deny rules, whenever I enable NAP on the DHCP scope, the client is not able to contact DHCP.
There is no NAP compliance message on the workstation. DHCP simply becomes not available until I remove NAP from the scope.
What causes this?
Exactly how is reporting mode set up and were do you read the reports on which systems pass and fail?