802.1 x authentication settings to trigger user authentication while user logs in

Hi

I currently have set up company's both wired and wireless network to gets 802.X authentication with Windows 10 client computers.

I also have set up so that both wired and wireless gets verified on the NAP by validating the Active directory user credentials. Ideally Active Directory users should get ParticularVLAN1 IP addressing if they logs on to system. Otherwise if no user logs on, system should getVLAN10

Everything works great on Wifi connections but have a problem only with computer having Ethernet connectivity.

Problem : Ethernet base connectivity.

When Computer is turned on it gets IP address of VLAN10 which is normal behaviour. But after User's login it still keeps on system IP inVLAN10 where ideally it should switch to VLAN1. I checked at network switch end which only gets initial request by Computer name asUser-Name:  host/hostname.doamin.com. When user logs in it doesn't receives any new EAPOL-Start Message with AD user name. 

Post user logs on if i connect or disconnect LAN card/cable on the system IP address gets to properVLAN1 with switch receiving proper EAPOL-Start Message with AD user name.

My GPO authentication method Computer and User authentication. I did was changing the EAPOL-Start Message transmission from "Transmit per IEEE 802.1X" to simply "Transmit" but didn't work.

Any help would be appreciated.

Kind regards
Deep